Search found 10 matches

by Kisazhi
Mon Sep 05, 2016 8:51 pm
Forum: Chat About the Kizashi
Topic: 114 days; Part II
Replies: 628
Views: 307859

Re: 114 days; Part II

I install a set of KYB on my son's 2010 SE AWD and notice the damping is garbage. The Oem is shot front and rear at 94K miles. They do improve a lot from tired OEM but the rebound and compression valving are definitely more geared for comfort than performance. Too bad the KW coil over cannot be set ...
by Kisazhi
Sat May 28, 2016 1:47 am
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Replacing ONE tpms
Replies: 8
Views: 6735

Re: Replacing ONE tpms

Yes, as long as they are compatible. I got one from discount tire. I did have to go back after about 15 miles. Seems to be a common thing to get it initiated twice for unknown reason.
by Kisazhi
Fri Apr 29, 2016 8:49 pm
Forum: Chat About the Kizashi
Topic: Knocking on right side of car
Replies: 5
Views: 5052

Re: Knocking on right side of car

If the swaybar bushing is just a bit loose it would rattle. Mine was about 0.5 mm too big and it rattle like you describe. I was not sure either at that time so I remove the bushing and then wrap the bar with electrical tape to make it thicker. The noise was gone after I did that. Try that before ch...
by Kisazhi
Sat Apr 09, 2016 2:35 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: My 2010 Suzi won't start
Replies: 127
Views: 132683

Re: My 2010 Suzi won't start

There got to be a sensor that is getting flaky in the steering wheel lock mechanism. I notice that there is a solenoid pulling every time I press the start button. The solenoid slide must got worn or gummed up with dirt and not giving good signal that it was unlocked. This got to be simple to fix.
by Kisazhi
Thu Apr 07, 2016 10:56 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Are these the bump stops?
Replies: 8
Views: 7724

Re: Are these the bump stops?

Yes. That is the one. I still have clunking noise after replacing the leaky rear shock. Found out the swaybar bushing is loose. Wrap about 4 wraps of electrical tape around the swaybar to make sure its the problem before ordering new bushing. Confirmed that it was the source of the noise. Also notic...
by Kisazhi
Fri Apr 01, 2016 11:14 am
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Are these the bump stops?
Replies: 8
Views: 7724

Re: Are these the bump stops?

It same type of material like the original. It have to be able to compress to absorb the bump. Its pretty common material for bump stop. I just realise the KYB one does not have the slit on the side. The inner diameter is the main problem. The original are loose and allow dirt and moisture to collec...
by Kisazhi
Thu Mar 31, 2016 9:24 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Are these the bump stops?
Replies: 8
Views: 7724

Re: Are these the bump stops?

I bought KYB brand replacement bump stop and the foam upper part looks exactly the same. The bottom is a bellow type that can compress and i think that is better than OEM.
by Kisazhi
Thu Mar 31, 2016 9:11 pm
Forum: Kizashi DIY Write-ups & Posts
Topic: My Dealer-less TPMS Tire Change Story
Replies: 360
Views: 287300

Re: My Dealer-less TPMS Tire Change Story

What people said about tire store reset procedure that come back after 15 miles is absolutely spot on. I have to get discount tire to do it the second one to have permanent fix. This is the most annoying thing from a few weeks of my kizashi ownership.
by Kisazhi
Thu Mar 31, 2016 9:05 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Rear Shock failure issue and TSB & Warranty Repair
Replies: 327
Views: 200445

Re: Rear Shock failure issue and TSB & Warranty Repair

Hi. Just got 2010 SE AWD for my son and got the same leaky rear shock. I got KYB revised bump stop and it looks exactly like the OEM revised bump stop. Could not tell any difference with the shock valving. The current 215/55/17 touring tires are too cushy to notice any performance difference.