Search found 82 matches

by Endeavour1200
Fri Jul 22, 2022 6:04 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: HUGE Vibration while braking
Replies: 3
Views: 1161

HUGE Vibration while braking

Recently I was driving at around 180 KMPH, and during braking the steering vibrated and wobbled very very heavily. The harder I braked the more violent the vibrations. So I went to a mechanic and he checked the brake system. Apparently the brake pads, rotors, calipers etc are in OK-ish shape. I want...
by Endeavour1200
Sat Jul 09, 2022 10:53 am
Forum: Chat About the Kizashi
Topic: Need your help identifying a part
Replies: 3
Views: 1550

Re: Need your help identifying a part

SAEED_KIZZY wrote: Sat Jul 09, 2022 9:43 am radiator for CVT transmission if your car is manual, no you don't need it.
makes sense, thank you
by Endeavour1200
Sat Jul 09, 2022 9:27 am
Forum: Chat About the Kizashi
Topic: Need your help identifying a part
Replies: 3
Views: 1550

Need your help identifying a part

Saw this part on a scrapped Kizashi, my car dosen't have it. Just below the front crash bar ahead of the radiator (pics attached)
What is it and should I buy it to put on my car?
Thanks
by Endeavour1200
Tue Jun 07, 2022 8:34 am
Forum: Chat About the Kizashi
Topic: Problem with throttle (RPMs fluctuate)
Replies: 6
Views: 2273

Re: Problem with throttle (RPMs fluctuate)

Whenever I experience "sputter" performance I suspect the fuel filter. Try replacing that, should be cheap. Sent from my SM-G975U1 using Tapatalk I could try that, don't know about the fuel filter availability though Turn heater fan speed to 0. Does it still do it? Trying to eliminate ac ...
by Endeavour1200
Wed Jun 01, 2022 5:00 pm
Forum: Chat About the Kizashi
Topic: Problem with throttle (RPMs fluctuate)
Replies: 6
Views: 2273

Re: Problem with throttle (RPMs fluctuate)

Pressure plate? Do you mean the Clutch pressure plate? If you have a manual then the rpms are not fluctuating like that, the car would be jerking violently enough to give you whiplash. Yes I mean clutch pressure plate, and yes I know it has nothing to do with this issue, but I stated it nonetheless.
by Endeavour1200
Tue May 31, 2022 3:19 pm
Forum: Chat About the Kizashi
Topic: Problem with throttle (RPMs fluctuate)
Replies: 6
Views: 2273

Problem with throttle (RPMs fluctuate)

When I'm holding the throttle steady, the rpms fluctuate alot. Like if I've held the throttle at 1500rpms, the rpm needle goes down to 1300, then to around 1650, then settles down to 1500, then after a few seconds down to 1300, 1650, 1500 and this cycle continues. I'm not sure as to what the problem...
by Endeavour1200
Sun Mar 06, 2022 4:48 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Rough Idle
Replies: 6
Views: 2616

Re: Rough Idle

Might want to check your motor mounts!
by Endeavour1200
Thu Feb 10, 2022 4:16 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: How to aim headlights
Replies: 6
Views: 3623

Re: How to aim headlights

The right hand side high beam points too far rightward and down, check attached picture.
Notice the right (yellow) high beam.

Removed headlight and made sure bulb is seated properly. Any fixes?
by Endeavour1200
Sun Feb 06, 2022 3:22 pm
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: How to aim headlights
Replies: 6
Views: 3623

Re: How to aim headlights

You can remove the large access cap and feel the auger gear turn the horizontal shaft pushing the up and down fixture . Sent from my iPhone using Tapatalk Once again you have helped me! The screw on top did not work, had to remove the headlights and aim them manually. Was a time demanding job but d...
by Endeavour1200
Mon Jan 31, 2022 5:39 am
Forum: Kizashi Technical Support & Problem Troubleshooting
Topic: Low RPM when idle
Replies: 3
Views: 1883

Re: Low RPM when idle

Similar problem with my MT Kizashi.

viewtopic.php?f=13&t=5549