thats it

I would recommend first checking for hydrocarbons in the cooling system. You could probably do this just by sniffing the coolant reserve bottle and if there’s a sharp smell to it that almost hurts your nose then you probably have a head gasket not sealing well. Does this car happen to be at 2010? Th...

I think going into another Kizashi with low miles or at least in very good shape. It’s a very good idea. You know the car and have all the resources here in the site of information and preemptive repairs to make this a very trustworthy car. Maybe even keeping a few parts on hand such as an ignition ...

I find it very risky to install a used cvt transmission but I guess that is behind us now. Both of these codes have a great deal to do with a pressure loss. I would recommend not to drive this before draining fluid and dropping pan then post a high quality picture of debris on pan floor , pick-up sc...

I’m just south of Erie Pennsylvania. Your car will still drive fine with this bearing going and you could drive it out and leave it with me for 2 full work days while you go visit Niagara Falls about an hour and a half away. This will be the cheapest and best,most enjoyable trip I would believe. Sen...

variable vavle timing solenoid. Looks like you need to pull it and put silicone sealer at oring

Yes I have . From what you describe Im pretty sure you have one of the bearings on the small transfer shaft. The cause of this failure is the bearing preload was set too tight from the factory. The preload must be checked after bearing is replaced. Trans must come out for this repair. I would highly...

peeam wrote:Do you still have the pigtail connector ?
Thanks

Sure


Sent from my iPhone using Tapatalk

Ona total repainting of the car , I would suggest a cheaper route that would look good. Paint the center section of the roof with Rustoleum gloss back with a foam roller . It will look amazing for probably $12. https://uploads.tapatalk-cdn.com/20240205/086682ca0cd8bfd75b69640b1415817f.jpg https://up...

Too far away for me but I can offer a nice transmission Ive gone through and put in upgraded primary unit and warranty for $850 Honestly, how much you think this job is going to end up costing me? The entire job at my shop is $1900 I move warranty up to 1 year parts and labor when we do complete jo...