Very nice and clean. I'm in the process of replacing my valve cover gasket again. I did so about a year ago but it started leaking again. Maybe I didn't seal it properly or something, especially with the sealant.
Crankshaft Position sensor and some other things
2011 Suzuki Kizashi Sport GTS 6MT (Black)
The shaded past for this car opens up a whole bunch of other possibilities that are not normal failures. Technician caused errors are the worst to find. I would start with checking the grounds there are two under the alternator one under the throttle body area and one on the front of the transmission. I would start there lean and tighten. The next item in question would be the starter. I would compare the sound to an Sx4 2010-13. It’s the same starter and much more common .You can find a cheap but good replacement on car-part.com . My guess is with your, that your Cvt failed and that a used one was installed and the incompatibility code for transmission came up and the engine computer was changed unnecessarily . This is just a guess. I highly doubt the timing is anything less than perfect. . A correlation code would be the code for a worn chain or more often the cam timing control solenoid . As far as the car waiting to set the code , it may be car has a few checks before turning the light on . I’m not sure on this one. Anyway after the starter , you could try the crank sensor. I could send you a good used one for $20 shipped.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- SAEED_KIZZY
- Posts: 513
- Joined: Wed Sep 13, 2017 2:31 pm
yes, my friend's car had the same problem at first with the door bottom light did not turn on after a while door switch failed. I found a problem with the door connector water passed the dust cover and damaged the connector.