Search found 6 matches
- Tue Jun 25, 2019 8:24 pm
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Blower motor not working
- Replies: 1
- Views: 2511
Blower motor not working
Motor does not blow on any setting. Pulled the motor and bench tested it. It runs when connected to a mower battery, though it does not spin easily when turned by hand. Connected the power line to a multi-meter and it showed 13 volts on low and stepped down as I increased the speed on the switch. Bu...
- Tue Jun 25, 2019 7:31 pm
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Stalling out at intersections.
- Replies: 15
- Views: 20326
Re: Stalling out at intersections.
Update for anyone who might be interested (2 years later) the stalling was the timing chain skipping. Luckily, under warranty.
- Sun Jun 25, 2017 4:07 pm
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Stalling out at intersections.
- Replies: 15
- Views: 20326
Re: Stalling out at intersections.
I thought it might be the Idle Air Control module, too. I hunted online and could never find one available for sale. Even downloaded the Chilton's guide for the car and ultimately found there isn't one. It must be built into the throttle body... Yesterday, I let the car run in park for nearly 45 min...
- Wed Jun 21, 2017 1:55 am
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Stalling out at intersections.
- Replies: 15
- Views: 20326
Re: Stalling out at intersections.
No issue with the air intake. It is more prone to stalling than previously. Once I drop into drive from neutral, it have to floor the pedal to get it going. Once it picks up to cruising speed (35ish) i can back off the pedal and drive normally. Until the next stop...
- Tue Jun 20, 2017 3:29 am
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Stalling out at intersections.
- Replies: 15
- Views: 20326
Re: Stalling out at intersections.
I appreciate the ideas, folks! Update: I have done the following: disconnected the battery overnight (didn't work). Checked the transmission fluid level (according to the manual) and that was fine. No change in operation. I will check the air intake. The throttle position sensor seems likely at this...
- Sat Jun 17, 2017 7:41 pm
- Forum: Kizashi Technical Support & Problem Troubleshooting
- Topic: Stalling out at intersections.
- Replies: 15
- Views: 20326
Stalling out at intersections.
About 6 weeks ago, my 2012 Kizashi SE (80k miles) began to do the following: I stop the car, typically at an intersection (light, sign, etc) and with my foot off the gas and on the brake (in automatic mode), the RPM dropped to 450-550, the car idle roughly and would frequently stall out. I found if ...