Hi Guys ,
attached are some images where the wires were broken --not the purge valve ) the blue plug ) the black T shaped plastic cover , can be removed and exposes all the wires
Rgds
Greg

Hi Murcod ,
Well what is the reply .
Rgds
Greg

Hi Murcold , I was not referring to members of the forum withholding I was referring to the dealers as was the case with your Hyundai. Please don`t get me wrong as I have thanked every body for their help . You are correct the broken wires was put up as a possible cause of the fault light , this mad...

Not sure about it being too short . Will have a look at the weekend , and see where it is that the break occurred . When I have looked at the motor , cover removed , all looked as it should all the restraining ties were in place , I doubt it has been hit , as it is perfect under the bonnet , but cou...

The dealer suspects that is has had a hit in the front and the motor was removed , thus hitting the Loom on the way out . I don`t think that was the case , as the wires show no signs of a hard hit , outer plastic casing is perfectly in tact , but the wire is broken inside the outer cover , very odd ...

finger nail test , in the wire run the finger nail over the wire , where the break is you will feel as oft section , that is the plastic outer cover but nothing below. It is easy when you try , it is obvious nothing solid in the middle , just a soft section . Maybe just my interpretation as an analo...

Hi guys , the kizashi is home after $ 543.00 , the two wires to the purge valve wer brokem in the loom down behind the inlet manifold where there is a "T " piece in the loom thet goes to the rear of the car and the other part goes to the ECU . They cut these out and there is a break in bot...

This is a picture of the Kizashi

Hi guys , just got the call , broken wires in the loom. Apparently both the negative trigger and the positive trigger wires have no continuity . So have to remove loom and find the break. They asked if it had been in an accident , as I purchased second hand , I don`t know , but I did have a very goo...

HI Murcod , thanks for this link , it is much easier to understand than the other service manual that I downloaded . On the scanner , at idle it does not show any % on the purge valve , when you hold about 2000 RPM then I get the % from the purge valve operating . However , when you turn the car off...