There are also two other options: 1) replace only 2 worn out plastic pads inside each door limiter. 2) add a 0.5-0.75 mm shim between plastic pad and rubber cushion . Just remove 2 screws, unfold 4 metal tabs, and you will see central plastic rod squeezed between 2 sets of plastic pad and rubber cus...

You just need to replace door limiters. Just did this on mine. Now doors are holding its position solid as a rock.

Found one more Kizashi that is having same issue. This post was recently published in one of facebook's groups: https://i.ibb.co/DRsHhTk/viber-2021-08-10-14-33-05-863.jpg I guess its time to install new crankshaft position sensor and if that wouldn't help - bring it to electrician to perform alterna...

This issue happened to me again yesterday. Brand new battery, 5 months since manufacturing date, only been used for 1 month. Battery voltage is 12,7V. Same errors, same issues (engine cranks but slowly shuts off after a moment). Car came back to life after 20 minutes of disconnecting negative cable ...

Brief: 3 error messages on dash: service engine, hill hold disabled & ESP disabled (error codes C1122, P2119, C1091) are signs of voltage drop. Replace your battery. Full story: Hello. Recently I had an issue with Kizashi when engine started as usual and I received 3 error messages on dash: serv...

I took off PCV valve and checked PCV tube. There is a negative pressure inside PCV tube, so it is ok. PCV valve opens up easily, but it doesn't seal up when negative pressure is removed. It leaks air just a bit into valve cover in passive state. Is this an issue and should PCV valve be replaced? I'm...

Reason and solution has been found now. After oil replacement situation got much better. Oil fill cap now lays flat, no excess pressure.

I just saw a Suzuki Kizashi which is rare in my region and neither owner nor I could decide whether what we saw is normal or not for this vehicle. With engine running oil fill cap was uscrewed but not removed. But it didn't just raise a bit to let gases escape, it started jumping about 3-8 mm high. ...