best option IMO... dab a bit of silicone on the back of the x-over case and "glue" it to the inside of the door card out of the way of any window motors or other electronics. They might make them pretty, but it's a major PITA to mount them somewhere they can be seen...KZChi wrote:Hey guys, quick question. If you did end up changing the tweeters, where would you place the crossover for the component speakers and how would it be wired?
Also, wiring is pretty self explanitory. Hard wire the factory wiring into the x-over input (might have to check out the service manual somewhere on this site to see which colors are positive and negetive) by cutting the factory harness off, then use the supplied wiring to wire the x-over to the speakers...